Assessments - 7, GPA: 4.1 ( )

Instruções de Operação Sony, Modelo CDX-M600R

Fabricante : Sony
Arquivo Tamanho: 3.7 mb
Arquivo Nome : Sony-CDX-M700R-CDX-M600R-Pdf-Rus.Pdf
Língua de Ensino: rusvenespt
Fotos e especificações  Sony  CDX-M600R
Ir para baixar

por este dispositivo também tem outras instruções :

Facilidade de uso

178 x 50 x 182 mm (w/h/d) Approx. 182 x 53 x 163 mm (w/h/d) Approx. 1.5 kg Card remote commander RM-X95 (CDX-M700R only) RM-X96 (CDX-M600R only) Parts for installation and connections (1 set) Rotary commander RM-X4S BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) Compact disc single adaptor CSA-8 CD changer (10 discs) CDX-828, CDX-737 MD changer (6 discs) MDX-65 Other CD/MD units with the Sony-BUS system Source selector XA-C30 DAB tuner unit XT-100DAB Digital equalizer preamplifier*2 XDP-210EQ, XDP-4000X Power requirements Dimensions Mounting dimensions Mass Supplied accessories Optional accessories Optional equipment *1 Equipped with front, rear and sub outputs: CDX-M700R only Equipped with front and rear outputs: CDX-M600R only *2 CDX-M600R only Design and specifications are subject to change without notice. 40 Troubleshooting guide The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. General Problem Cause/Solution No sound. • Cancel the ATT function. • Set the fader control to the centre position for two-speaker system. • Press (+) of the VOL button to adjust the volume. The contents of the memory • The power cord or battery has been disconnected. have been erased. • The reset button has been pressed. —► Store again into the memory. No beep sound. The beep sound is cancelled (page 35). The sound is noisy. You are using a mobile phone. CD/MD playback Problem Cause/Solution A disc cannot be loaded. • Another CD is already loaded. • The CD is forcibly inserted upside down or in the wrong way. Playback does not begin. Defective MD or dirty CD. A disc is automatically ejected. The ambient temperature exceeds 50°C. CD will not be ejected. You have closed the front panel or pushed the disc forcibly into the unit while the unit was ejecting the disc after you pressed Z. —► Press the reset button. The operation buttons do not function. Press the reset button. The sound skips due to • The unit is installed at an angle of more than 60°. vibration. • The unit is not installed in a sturdy part of the car. The sound skips. A dirty or defective disc. Cannot turn off the "........" You cannot label CDs unless you connect a CD unit with the indication. custom file function. —► Press (list) for two seconds. 41 Radio reception Problem Cause/Solution Preset tuning is not possible. • Store the correct frequency in the memory. • The broadcast signal is too weak. The stations cannot be received. Connect a power aerial control lead (blue) or accessory power The sound is hampered by supply lead (red) to the power supply lead of a car's aerial noises. booster. (Only when your car has built-in FM/MW/LW aerial in the rear/side glass.) Automatic tuning is not The broadcast signal is too weak. possible. t Use manual tuning. The "ST" indication flashes. • Tune in the frequency accurately. • The broadcast signal is too weak. —► Set to the Mono mode (page 17). RDS Problem Cause/Solution The SEEK starts after a few The station is non-TP or has weak signal. seconds of listening. t Press (AF/TA) to select "AF TA oft." No traffic announcements. •Activate "TA." • The station does not broadcast any traffic announcements despite being TP. —► Tune to another station. PTY displays "None." The station does not specify the programme type. DSP functions Problem Cause/Solution No sound, or sound is too low. The volume of the speakers may have been automatically lowered in order to maximize the effect of the listening position adjustment. —► Press < or , to adjust the balance. The speaker balance can be set separately for DSP on mode and DSP off mode (page 29). 42 Error displays (when an optional CD/MD unit is connected) The following indications will flash for about five seconds, and an alarm sound will be heard. Display Cause Solution NO Mag The disc magazine is not inserted in the CD/MD unit. Insert the magazine in the CD/MD unit. NO Disc No disc is inserted in the CD/MD unit. Insert discs in the CD/MD unit. NG Discs A CD/MD cannot play because of some problem (dirty CD, defective MD etc.). Insert another CD/MD. Error*1 A CD is dirty or inserted upside down.*2 Clean or insert the CD correctly. An MD does not playback because of some problem.*2 Insert another MD. Blank*1 No tracks have been recorded on an MD.*2 Play an MD with recorded tracks on it. PushReset The CD/MD unit cannot be operated because of some problem. Press the reset button on the unit. Not Ready The lid of the MD unit is open or the MDs are not inserted properly. Close the lid or insert the MDs properly. High Temp The ambient temperature is more than Wait until the temperature goes 50°C. down below 50°C. *1 When an error occurs during playback of an CD or MD, the disc number of the CD or MD does not appear in the display. *2 The disc number of the disc causing the ...

Este manual também é adequado para os modelos :
Unidade - CDX-M700R (3.7 mb)

Escreva a sua própria avaliação do dispositivo

Seu nome :
Introduza os dois dígitos :